So, I have a short question. How to open some port range in ISPC3? When I input ports like xxx:yyy I get ERROR 1. tcp_ports_error_regex Should I use some other syntax? Or is it disabled? I remember it was possible in ISPC2.
Port ranges are disabled at the moment as the regex for the input test does not allow them. I added : to the regex, so if you upadte to the ltesat svn revision then port ranges should work now.
Hi I am using ISPC 3.0.1.3 I am trying to open a range for passive FTP The firewall page does accept the : now as you mentioned (thanks), but it does not open the whole range. It seems only to open the start port: e.g. my entry in ISPC server.name 20,21,22,25,80,110,143,443,8810,20000:30000 and iptables -L shows: Code: Chain PUB_IN (4 references) target prot opt source destination ACCEPT icmp -- anywhere anywhere icmp destination-unreachable ACCEPT icmp -- anywhere anywhere icmp echo-reply ACCEPT icmp -- anywhere anywhere icmp time-exceeded ACCEPT icmp -- anywhere anywhere icmp echo-request PAROLE tcp -- anywhere anywhere tcp dpt:ftp-data PAROLE tcp -- anywhere anywhere tcp dpt:ftp PAROLE tcp -- anywhere anywhere tcp dpt:ssh PAROLE tcp -- anywhere anywhere tcp dpt:smtp PAROLE tcp -- anywhere anywhere tcp dpt:www PAROLE tcp -- anywhere anywhere tcp dpt:pop3 PAROLE tcp -- anywhere anywhere tcp dpt:imap2 PAROLE tcp -- anywhere anywhere tcp dpt:https PAROLE tcp -- anywhere anywhere tcp dpt:8810 PAROLE tcp -- anywhere anywhere tcp dpt:20000 DROP icmp -- anywhere anywhere DROP all -- anywhere anywhere whereas our entry in question should read Code: PAROLE tcp -- anywhere anywhere tcp dpts:20000:30000 or am I terribly wrong here? best regards and keep up the good work, Christian
