Hello I am trying to add a virtual IP address to be used for a website. I followed the instructions in ISPCONFIG 3 guide by creating a file in /etc/sysconfig/network-scripts/ifcfg-eth0:0 this is what I have in the file DEVICE=eth0:0 NM_CONTROLLED=yes TYPE=Ethernet BOOTPROTO=static IPADDR=192.168.1.135 PREFIX=24 GATEWAY=192.168.1.1 DEFROUTE=no IPV4_FAILURE_FATAL=yes IPV6INIT=no NAME="System eth0:0" HWADDR=54:04:A6:A6:90:27 DNS2=75.75.76.76 DNS1=75.75.75.75 USERCTL=no NETMASK=255.255.255.0 my ifcfg-eth0 is DEVICE=eth0 NM_CONTROLLED=yes ONBOOT=yes HWADDR=54:04:A6:A6:90:27 TYPE=Ethernet BOOTPROTO=none IPADDR=192.168.1.134 PREFIX=24 GATEWAY=192.168.1.1 DEFROUTE=yes IPV4_FAILURE_FATAL=yes IPV6INIT=no NAME="System eth0" DNS2=75.75.76.76 DNS1=75.75.75.75 USERCTL=no when I restart the network, or reboot the system I still don't have interface eth0:0 up this is the output of ifconfig eth0 Link encap:Ethernet HWaddr 54:04:A6:A6:90:27 inet addr:192.168.1.134 Bcast:192.168.1.255 Mask:255.255.255.0 inet6 addr: fe80::5604:a6ff:fea6:9026/64 Scope:Link UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:511476 errors:0 dropped:0 overruns:0 frame:0 TX packets:618897 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:63977793 (61.0 MiB) TX bytes:563825845 (537.7 MiB) lo Link encap:Local Loopback inet addr:127.0.0.1 Mask:255.0.0.0 inet6 addr: ::1/128 Scope:Host UP LOOPBACK RUNNING MTU:16436 Metric:1 RX packets:98795 errors:0 dropped:0 overruns:0 frame:0 TX packets:98795 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:0 RX bytes:18901814 (18.0 MiB) TX bytes:18901814 (18.0 MiB) Am I missing a step or something? How can I get this to work? Can anybody help? Thanks!