I'm about to install Debian Sarge 3.1 on a production server (running at the moment Fedora RC4) I'm going to use The Perfect Setup - Debian Sarge (3.1) from the guru named 'falko' I've done some 'test' runs on an other server and have some questions. 1) At Install/Remove Some software (http://www.howtoforge.com/perfect_setup_debian_sarge_p3) I do not get the Yes.. Is this a problem? 2) At Postfix/POP3/IMAP (http://www.howtoforge.com/perfect_setup_debian_sarge_p4) After doing the: I get more things to setup after: I get this: After that it's back to normal again I think.. I've left the default settings for the 'new' stuff.. Any info about all this appreciated! PS.. Postfix/POP3/IMAP in the To see if SMTP-AUTH and TLS work properly now run the following command: The image of the Telnet session is missing/wrong. It's set to: http://www.howtoforge.com/images/31.gif It should be: http://www.howtoforge.com/images/perfect_setup_debian_sarge/31.gif
One more thing... I would like to start using the Apache mod_cband (from the Howto @ http://www.howtoforge.com/mod_cband_apache2_bandwidth_quota_throttling) Now do I need to install this at the same time when I do the Apache section (apt-get install apache2 apache2-doc) or can I install this later? I will also be using ISPconfig on the system!
If you are going to install mod_cband & Debian you might use this http://e-corona.org/blog,245 (note that pkg is not the one mentioned in manual but : libapache2-mod-cband_0.9.7.4-0bpo1_i386.deb )