clamav and php 7.3 failed

Discussion in 'Installation/Configuration' started by pecka33, Sep 24, 2023.

  1. pecka33

    pecka33 Member

    i checked via command server status failed and get
      UNIT                     LOAD   ACTIVE SUB    DESCRIPTION                    >
    ● clamav-clamonacc.service loaded failed failed ClamAV On-Access Scanner
    ● php7.3-fpm.service       loaded failed failed The PHP 7.3 FastCGI Process Man>
    LOAD   = Reflects whether the unit definition was properly loaded.
    ACTIVE = The high-level unit activation state, i.e. generalization of SUB.
    SUB    = The low-level unit activation state, values depend on unit type.
    2 loaded units listed.
    Any idea what should i check? Sometimes when i did reboot of my server, i had to install for example memcache for php 5.6. Dont know why, bud after reboot is sometimes removed.

    Thank you.

Share This Page