Hi again guys. Today i am doing again an installation of a SUSE 12.1 server (minimal install) And I am about to put this server as a production server. Following again falkos guide at .. http://www.howtoforge.com/virtualization-with-kvm-on-an-opensuse-11.4-server which is basically the same i am stuck at the point where i need to create the dummy0 interface and be able to use it from startup (boot) time. Please help me out here i am stuck here. Thanks Ed I tried with modprobe but can't seem to get it to work.
Thank you for the reply falco. Maybe you remember my other post about setting xen over Centos6.2 Now i am setting kvm over Suse 12.1 minimal install. And I have again the public IP addresses for the server. If you remember I have the server ip xxx.xxx.xxx.xxx and the other 4 ip's the third octect changes and I need to create a bridge nat wont work since all the IP's are public. So i need to create a bridge which according to your tutorial works but i need to create the dummy0 to use it as the bridge and do not use eth0 as the bridge. This is of course a different server but needs to be installed same as centos (my other post) but with suse. My other post was this .. http://www.howtoforge.com/forums/showthread.php?t=57674 and now i am doing the same but with suse 12.1 Thanks Falco. Ed.
