Gnome failed loading module i810

I found an problem while typing startx.

This is the error which it displayed:

Failed to load module "i810" (module does nit exist,0)
No drivers available

I found that the problem had something to do with my graphics card which is builded into the mainboard of the server.

But I can I fix this problem??

 

What happens when you run

Code:

modprobe i810

or

Code:

insmod i810

?

 

Nothing

 

No error message? That's good. Then try to start X again.

 

Same


But I just reinstalled my system with graphical desktop and now it works. Only I had to swap my ide drive with my sata drive, Somehow it doesnt work on the ide drive

 

i810 fails to load

I get the same message. I show that the i810 kernel module is loaded but Xorg still cannot find it.

What configuration file needs to be changed to load i810 at boot?

TIA,

Edward Hooper

 

You can add

Code:

modprobe i810

to /etc/rc.local.

 

i810 module

I found through trial and error that X.org is looking for the i810 X.org module not the i810 kernel module.

The i810_driver.so X.org module does not exist in this version of X.org (I don't remember the version number) but there is an intel_driver.so module that almost, but not quite, works and needs some specific tweaking. I will start a new thread for that.\

Thanks for the help...

 

Possible help...

Hi,

Ok, I have a CompaQ Evo 51S, build-on/in graph card, i810. This thing seelms to need agpgart, look at this info

http://www.freebsd.org/doc/en_US.ISO8859-1/books/handbook/x-config.html

I have agpgart, but for blisters, I dont know what 2DO with it...

You might want to let X figure out a fresh xorg.conf. Wanna? Do this:

I get a grey ... nothing. possibly because I need agpgart...
Still figuring that one out...some help is welcome!!!

Have fun! I know I will...

Thor