I have Openfiler 2.3 running and I'm trying to get DRBD configured. In the HowtoForge doc http://www.howtoforge.com/installing-and-configuring-openfiler-with-drbd-and-heartbeat, the DRBD.conf file has references to /dev/sda3 and /dev/sda5. My OS is running on sda and my volumegroup is on /dev/sdb. Should I use /dev/sdb3 and /dev/sdb5 instead?
Here it is: /dev/sda1-3 is my USB key /dev/sdb1 is my volumegroup /dev/sdb2 empty partition I created from within Openfiler GUI /dev/sdb3 empty partition I created from within Openfiler GUI /dev/dm-Op1 iSCSI volume within /dev/sdb1 volumegroup /dev/dm-01 partition for /var/log (moved from USB key) Disk /dev/sda: 2000 MB, 2000682496 bytes 64 heads, 32 sectors/track, 1907 cylinders Units = cylinders of 2048 * 512 = 1048576 bytes Device Boot Start End Blocks Id System /dev/sda1 * 1 100 102384 83 Linux /dev/sda2 101 1707 1645568 83 Linux /dev/sda3 1708 1907 204800 82 Linux swap / Solaris Disk /dev/sdb: 733.4 GB, 733478912000 bytes 255 heads, 63 sectors/track, 89173 cylinders Units = cylinders of 16065 * 512 = 8225280 bytes Device Boot Start End Blocks Id System /dev/sdb1 100 89173 715486905 8e Linux LVM /dev/sdb2 1 38 305203+ 8e Linux LVM /dev/sdb3 39 99 489982+ 8e Linux LVM Partition table entries are not in disk order Disk /dev/dm-0: 368.9 GB, 368998088704 bytes 255 heads, 63 sectors/track, 44861 cylinders Units = cylinders of 16065 * 512 = 8225280 bytes Device Boot Start End Blocks Id System /dev/dm-0p1 1 44861 360345918+ fb Unknown Disk /dev/dm-1: 10.7 GB, 10737418240 bytes 255 heads, 63 sectors/track, 1305 cylinders Units = cylinders of 16065 * 512 = 8225280 bytes Disk /dev/dm-1 doesn't contain a valid partition table