I have 5.3 with persistent Knoppix, it saves OK and connects to the internet OK but will not properly save the Wlan0 setup. When booted up it shows Etho disconnected and Wlan0 disconnected icon on the bottom bar. I click on the small penguin and then Network/ Internet Configuration and get network check and then click to connect Wlan0 it comes up connected and then disconnected followed by network check and from there I have to go through all the configuration some times only so far through the configuration and sometimes all the way through it. I can save everything else so is there a way of saving this without all the hastle? knoppix@Knoppix:~$ iwconfig lo no wireless extensions. eth0 no wireless extensions. wmaster0 no wireless extensions. wlan0 IEEE 802.11g ESSID:"BTHomeHub-7D1C" Mode:Managed Frequency:2.412 GHz Access Point: 00:1D:68:51:9A:C1 Bit Rate=1 Mb/s Tx-Power=27 dBm Retry min limit:7 RTS thrff Fragment thr=2346 B Link Quality=74/100 Signal level=-33 dBm Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0 Tx excessive retries:0 Invalid misc:0 Missed beacon:0 knoppix@Knoppix:~$
