Hi all! I have an old PCMCIA card and I would like to use in a newly installed centos5.6. I want to use, but I do not know how. ifconfig-a does not return the card details ... I can see the pci devices both the controller and the PCMCIA card as well. I read, I have to load the kernel module yenta to use the pcimcia card, but I couldn't. The /sbin/modprobe -l | grep "yenta" does not return anything, and do not have either of these modules in libary (find /lib/modules/`uname -r`/kernel/ | grep yenta) Please any help on how I can move forward welcome, or where should I start to search or indeed whether the card can support? How to config PCMCIA Card at CentOS5 now? Thanks Victor # lspci -vvv 03:01.0 CardBus bridge: Ricoh Co Ltd RL5c476 II (rev ba) Subsystem: Dell Device 0233 Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx- ... BridgeCtl: Parity- SERR- ISA- VGA- MAbort- >Reset- 16bInt- PostWrite+ 16-bit legacy interface ports at 0001 Kernel driver in use: yenta_cardbus 04:00.0 Ethernet controller: Realtek Semiconductor Co., Ltd. Device 8039 (rev 10) Subsystem: Surecom Technology Device 0428 Control: I/O- Mem- BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx- ... Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=0mA PME(D0-,D1+,D2+,D3hot+,D3cold-) Status: D0 NoSoftRst- PME-Enable- DSel=0 DScale=0 PME- # lspci -nn 04:00.0 Ethernet controller [0200]: Realtek Semiconductor Co., Ltd. Device [10ec:8039] (rev 10) # yum list | grep pcmciautils pcmciautils.x86_64 014-5 installed # uname -a Linux localhost.localdomain 2.6.18-238.el5 #1 SMP Thu Jan 13 15:51:15 EST 2011 x86_64 x86_64 x86_64 GNU/Linux