ID / password not working for fisrt connection

Discussion in 'Installation/Configuration' started by Keoz, Sep 2, 2022.

  1. Keoz

    Keoz Member

    I just installed ISPConfig 3.2 thanks to this tutorial :

    During installation I switched ISPConfig default password, e.g. [24rf56KL] to “admin“, so there should be no mistake using “admin“ as the password... ! As wasn't prompt to set a connection USERNAME, I supposed that default one was “admin“ too. But first connection fails if using “admin“ for both the USERNAME and the PASSWORD.

    Then I went for a passord reset, giving username “admin“ and the email address set during installation, but I received none message in my mailbox.

    If a reinstallation is needed, are there “do“ and “don't do“ to know to avoid connection failure when using “admin“ for both the USERNAME and PASSWORD ?

    Can you plesae help ?

    Last edited: Sep 2, 2022
  2. till

    till Super Moderator Staff Member ISPConfig Developer

  3. Keoz

    Keoz Member


Share This Page