loop-aes in etch

loop-aes now comes with the installer in etch.

however I can get only to the point below cannot seem to create the
/ mount point for root or home?

1 primary 501.7mb F ext3 /boot
2 primary 1.4gb K crypto not active
3 primary 9.0gb K crypto not active
pri/log FREE SPACE 2gb

in the case of the root partition 1.4gb I did set the mount / as root
same for home 9.0 gb but it comes up as not active?


any suggestions would be welcome

hotchilli

 

report a bug

apprently this is a bug in etch installer ???????????/

 

If you think it's a bug you can report it here: http://www.debian.org/Bugs/