Hello All, I have just complied Snort 2.9.0.4 under Ubuntu 10.10 x86_64 installed with all Lamp package. The syntax i used to compile Snort as follows below ********************************************* ~/snort-2.9.0.4# ./configure -with-mysql —prefix=/usr/local/snort —enable-ipv6 —enable-gre \-enable-mpls -enable-targetbased —enable-decoder-preprocessor-rules \-enable-ppm -enable-perfprofiling —enable-zlib —enable-active-response \-enable-normalizer —enable-reload —enable-react —enable-flexresp3 *********************************************** in snort.conf i set log as follow ******************************************************************** output database: log, mysql, user=snort password=password dbname=snort host=localhost sensor_name=gfn-sec-sn1 ******************************************************************** now when i run snort " /usr/local/snort/bin/snort -c /etc/snort/snort.conf -i eth2" I get following error ************************************************************ Log directory = /var/log/snort database: ‘mysql’ support is not compiled into this build of snort ERROR: If this build of snort was obtained as a binary distribution (e.g., rpm, or Windows), then check for alternate builds that contains the necessary ‘mysql’ support. If this build of snort was compiled by you, then re-run the the ./configure script using the ‘—with-mysql’ switch. For non-standard installations of a database, the ‘—with-mysql=DIR’ syntax may need to be used to specify the base directory of the DB install. See the database documentation for cursory details (doc/README.database). and the URL to the most recent database plugin documentation. Fatal Error, Quitting.. ************************************************************ Since i am not so expert with Linux should i point somewhere for MySQL or i missed something. Please Advice Thanks