"Solved" ISPC3 using private IP and NATed to public

Discussion in 'Installation/Configuration' started by ganewbie, Apr 3, 2018.

  1. ganewbie

    ganewbie Member HowtoForge Supporter

    Hello,
    We have couple of setups of ISPC3 (Debian8 and 9) with private address and NATed to the public IP through the edge router.
    The question now is what do we enter in the image below?
    IP Address , Subnetmask and Gateway ( Do we enter the public or private data?

    Thanks,
     

    Attached Files:

    ganewbie, Apr 3, 2018
    #1
  2. till

    till Super Moderator Staff Member ISPConfig Developer

    This is the configuration for the network card of the server, there you enter private IP details.
     
    till, Apr 3, 2018
    #2
    ganewbie likes this.
  3. ganewbie

    ganewbie Member HowtoForge Supporter

    Sounds good,
    What I don't understand is why the gateway always 0.0.0.0 however it is correct when you do ifconfig from the terminal.
    Our issue is the servers do not talk together.
    Will test and report back.
    Thanks Till,
     
    ganewbie, Apr 3, 2018
    #3
  4. till

    till Super Moderator Staff Member ISPConfig Developer

    These settings are not used by default, so it does not matter much what is in there. Check the network config in the appropriate Debian files, adjust it there, and leave the settings in ISPConfig as they are.
     
    till, Apr 3, 2018
    #4
    ganewbie likes this.
  5. ganewbie

    ganewbie Member HowtoForge Supporter

    Thanks Till,
    Our issue was in the edge router, thanks for the feedback.
    Cheers,
     
    ganewbie, Apr 4, 2018
    #5

Share This Page