USB modem installed - how to setup & connect ?

Discussion in 'Installation/Configuration' started by emuube, May 1, 2006.

  1. emuube

    emuube New Member

    I have a USB sagem modem installed under FC5. The driver comes precompiled in fc5 and i've installed the ueagle firmware.
    According to
    /var/log/messaages the modem is operational with firmware version 44e2ea17;
    cat /sys/bus/driver/ueagl-atm/3-1:1.0/human_status gives "modem is operational"
    Network Config has a device ADSL-USB modem bit only shows ethx for "access/mounting" to it. The modem is in USB connector 3-1.
    If you have a USB modem under FC5 can you pls lead me through the steps to allow connection to the inet.
  2. falko

    falko Super Moderator Howtoforge Staff

    What's in your network configuration file?
    What's the output of

Share This Page