One more strange thing i have noticed and i cannot figure out if its due to cyrus config or exim... If a sender sends to a capital letters address...
Of course, everytime i make any changes i restart the appropriate services... But this problem still remains SMTP takes sometimes up to 10 seconds...
No, in my config exists only this : accept authenticated = * control = submission/sender_retain Not added again, found this...
It seems to work. Now only two minor problems remain... SMTP authentication takes sooo long to complete even in the LAN network...:o Finally the...
OK, i'll try this and let you know.. Now i have my system up&running with 124 mail accounts and seems fine... Now it only needs fine-tunning......
What this setting will do? I would like to have my users authenticate when trying to send because i am planning to use SMTP and from outside, so i...
Tried to upgrade to latest versions of Horde, imp, etc.. Everything seems fine but in the upgrade doc of Horde says it needs MDB2_Schema so it...
Got this trying to send to you from Outlook with SMTP authorization: 2008-12-03 16:19:50 no host name found for IP address 192.168.10.199...
OK, if and whenever you have the time it would be good to know how to make this work...(compare our configs..) maybe some of my clients want to...
Yes that was correct... probably some typing mistake... now reverting back to my original conf, and fixing the hosts that you stated seems to work...
Thunderbird does exactly the same behavior... ok hosts corrected... but in the domain section existed one '!' .. is it needed? Now what ever...
Unfortunately after this change it replies relay denied... here is my config which is copied from the how to except for the spam section which...
Ok so my thoughts were right. I will try this.. In the meantime i tried the relay_from_hosts field but after set my network there,...
Yes SMTP authentication is used.. (without this doesn't work at all).. Also if i set qualify_domain the message pass but in the receiver...
probably writing on the same moment!!! logs are on the previous message (edited)
Separate names with a comma.