Recent Content by Paul

  1. Paul
    Post

    After setup...

    Setting up in expert26 mode has ask me for boot modules for 2 my ethernet cards. But this time setup was down because of unstable power. Next time...
    Post by: Paul, Oct 12, 2005 in forum: HOWTO-Related Questions
  2. Paul
    Post

    After setup...

    I have edit /etc/network/interfaces so: #The loopback network interface auto lo iface lo inet loopback #The orimary network interface...
    Post by: Paul, Oct 12, 2005 in forum: HOWTO-Related Questions
  3. Paul
    Post

    After setup...

    Sorry, last question was incorrect. I found solution alrady ;)
    Post by: Paul, Oct 12, 2005 in forum: HOWTO-Related Questions
  4. Paul
    Post

    After setup...

    And as gateway for eth1 sould I set the IP of eth0? (i will use this mashine as gateway LAN - Internet)
    Post by: Paul, Oct 11, 2005 in forum: HOWTO-Related Questions
  5. Paul
    Post

    After setup...

    If I use 2 network adaptors (eth0 for Internet, eth1 for LAN), should I type all IP-addresses etc. in file /etc/network/interfaces or create...
    Post by: Paul, Oct 11, 2005 in forum: HOWTO-Related Questions
  6. Paul
    Post

    After setup...

    Thanks, guys! I can do it using pico or nano. But I'm very yung linuxoid.:confused: Wait for more questions from me, OK?
    Post by: Paul, Oct 11, 2005 in forum: HOWTO-Related Questions
  7. Paul
    Thread

    After setup...

    I have install Sarge using instructions from http://www.howtoforge.com/perfect_setup_debian_sarge, everything was great! And when I try to edit...
    Thread by: Paul, Oct 10, 2005, 12 replies, in forum: HOWTO-Related Questions